Failure analysis of waste wire recycling equipment

Waste wire recycling equipment is a recycling line for dry separation of waste wire and cable. The characteristics of the machine are that the large and small lines can be broken and separated at the same time, no need to be classified, the structure is novel, the output is large, and the power consumption is low. High sorting rate, one-time feeding, and multi-machine cooperation. The waste wire recycling equipment not only solves the problems in the method of incinerating copper, but also improves the quality of recycled copper, recycles plastics, and solves environmental pollution. The failure analysis of waste wire recycling equipment during use is as follows:

1. In the actual processing process, due to different materials, the size of the cut copper particles and plastic particles is also different. In order to achieve the ideal separation effect, wind and vibration forces need to be adjusted according to the material. For example, if the waste wire recycling equipment discharges slowly, the vibration frequency and wind force can be accelerated. However, if the vibration frequency is too fast, if the time the material is in the air separator is too short, some plastic particles will come out of the copper end.

2. In the air flow separation of waste wire recycling equipment, under the action of wind, light plastic particles are blown out from the material conveyed by the crusher, and moved to the rear end of the air flow separator under the action of vibration. The heavy copper particles cannot be blown away by the wind, so they move to the front end of the airflow separator under the action of vibration.

3. The waste wire recycling equipment is equipped with a linear screen. Some users will quickly adjust the vibration frequency of the air separator to screen unsatisfactory materials, which can improve the overall efficiency and improve the overall efficiency. If the copper particles are mixed with a large amount of plastic particles and do not want to be reprocessed, the vibration frequency of the air separator should be adjusted appropriately, and the wind force should be adjusted slightly. If the material is blown out above the air separator or at the front and rear ends, rather than by vibration, the wind force needs to be adjusted.

Suny Group : http://www.sunyrecycle.com/，All rights reserved。